|
Schweitzer, N., Apter, Y., Ben-David, J., Liebermann, D. G., & Parush, A. (1995). A field study of braking reactions during driving II: Minimum driver braking times. Ergonomics, 38(9), 1903–1910.
Abstract: The minimum total braking time (i.e. the braking reaction time plus the accelerator-to-brake movement time) plays an important role in defining a minimum following gap (MFG). This study was designed to obtain a lower limit for this gap. Total braking times (TBT) of a group of 51 male and female young athletes were monitored during real driving conditions. Sudden braking applied by a leading private passenger vehicle initiated the trials. A within-subject design was used to study the effects of different factors on braking time. Individuals performed a series of semi-counterbalanced trials at two following distances (6 and 12 m), two speeds (60 and 80 km/h) and three expectancy stages (naïve driving, partial knowledge, and full knowledge of the forthcoming manoeuvre). A three-way repeated measures ANOVA showed no major effects of ‘speed’, but major effects of the ‘expectancy’ and the ‘distance’ factors. The experiment yielded a mean TBT of 0·678 s (SD = 0·144 s) for trials averaged over distances and speeds in the naïve condition only. The data emphasize the role played by pre-cues in the braking response prior to emergency stops. Both the level of awareness of the forthcoming manoeuvre and the distance between vehicles appear to determine the response time. The descriptive statistics presented may also provide the basis for an objective, acceptable and legally valid minimum time gap for prosecution of ‘careless’ drivers.
|
|
|
Liebermann, D. G., Krasovsky, T., & Berman, S. (2008). Planning maximally smooth hand movements constrained to nonplanar workspaces. J Mot Behav, 40(6), 516–531.
Abstract: The article characterizes hand paths and speed profiles for movements performed in a nonplanar, 2-dimensional workspace (a hemisphere of constant curvature). The authors assessed endpoint kinematics (i.e., paths and speeds) under the minimum-jerk model assumptions and calculated minimal amplitude paths (geodesics) and the corresponding speed profiles. The authors also calculated hand speeds using the 2/3 power law. They then compared modeled results with the empirical observations. In all, 10 participants moved their hands forward and backward from a common starting position toward 3 targets located within a hemispheric workspace of small or large curvature. Comparisons of modeled observed differences using 2-way RM-ANOVAs showed that movement direction had no clear influence on hand kinetics (p < .05). Workspace curvature affected the hand paths, which seldom followed geodesic lines. Constraining the paths to different curvatures did not affect the hand speed profiles. Minimum-jerk speed profiles closely matched the observations and were superior to those predicted by 2/3 power law (p < .001). The authors conclude that speed and path cannot be unambiguously linked under the minimum-jerk assumption when individuals move the hand in a nonplanar 2-dimensional workspace. In such a case, the hands do not follow geodesic paths, but they preserve the speed profile, regardless of the geometric features of the workspace.
|
|
|
Melzer, I., Liebermann, D. G., Krasovsky, T., & Oddsson, L. I. E. (2010). Cognitive load affects lower limb force-time relations during voluntary rapid stepping in healthy old and young adults. J Gerontol A Biol Sci Med Sci, 65(4), 400–406.
Abstract: BACKGROUND: Quick step execution may prevent falls when balance is lost; adding a concurrent task delays this function. We investigate whether push-off force-time relations during the execution of rapid voluntary stepping is affected by a secondary task in older and young adults. METHODS: Nineteen healthy older adults and 12 young adults performed rapid voluntary stepping under single- and dual-task conditions. Peak power, peak force, and time to peak force during preparatory and swing phases of stepping were extracted from center of pressure and ground reaction force data. RESULTS: For dual-task condition compared with single-task condition, older adults show a longer time to reach peak force during the preparation and swing phases compared with young adults (approximately 25% vs approximately 10%, respectively). Peak power and peak force were not affected by a concurrent attention-demanding task. CONCLUSION: Older adults have difficulty allocating sufficient attention for fast muscle recruitment when concurrently challenged by an attention-demanding task.
|
|
|
Biess, A., Flash, T., & Liebermann, D. G. (2011). Riemannian geometric approach to human arm dynamics, movement optimization, and invariance. Phys Rev E Stat Nonlin Soft Matter Phys, 83(3 Pt 1), 031927.
Abstract: We present a generally covariant formulation of human arm dynamics and optimization principles in Riemannian configuration space. We extend the one-parameter family of mean-squared-derivative (MSD) cost functionals from Euclidean to Riemannian space, and we show that they are mathematically identical to the corresponding dynamic costs when formulated in a Riemannian space equipped with the kinetic energy metric. In particular, we derive the equivalence of the minimum-jerk and minimum-torque change models in this metric space. Solutions of the one-parameter family of MSD variational problems in Riemannian space are given by (reparameterized) geodesic paths, which correspond to movements with least muscular effort. Finally, movement invariants are derived from symmetries of the Riemannian manifold. We argue that the geometrical structure imposed on the arm's configuration space may provide insights into the emerging properties of the movements generated by the motor system.
|
|
|
Berman, S., Liebermann, D. G., & McIntyre, J. (2014). Constrained Motion Control on a Hemispherical Surface – Path Planning. J Neurophysiol, 111(5), 954–968.
Abstract: Surface-constrained motion, i.e., motion constraint by a rigid surface, is commonly found in daily activities. The current work investigates the choice of hand paths constrained to a concave hemispherical surface. To gain insight regarding the paths and their relationship with task dynamics, we simulated various control policies. The simulations demonstrated that following a geodesic path is advantageous not only in terms of path length, but also in terms of motor planning and sensitivity to motor command errors. These stem from the fact that the applied forces lie in a single plane (that of the geodesic path itself). To test whether human subjects indeed follow the geodesic, and to see how such motion compares to other paths, we recorded movements in a virtual haptic-visual environment from eleven healthy subjects. The task was comprised of point-to-point motion between targets at two elevations (30 degrees and 60 degrees ). Three typical choices of paths were observed from a frontal plane projection of the paths: circular arcs, straight lines, and arcs close to the geodesic path for each elevation. Based on the measured hand paths, we applied k-means blind separation to divide the subjects into three groups and compared performance indicators. The analysis confirmed that subjects who followed paths closest to the geodesic produced faster and smoother movements, compared to the others. The 'better' performance reflects the dynamical advantages of following the geodesic path, as shown by the simulations, and may also reflect invariant features of the control policies used to produce such a surface-constrained motion.
|
|